|
Following are Kiwacans range of Microchip PIC based prototyping boards and modules.
These products support a wide range of Microchip PIC12, PIC16, PIC18, PIC24, PIC32, dsPIC30 and dsPIC33 Microcontrollers.
Please see our products datasheets for more details.
KPIC-P32S1
|
Supports Microchip PIC32Starter Kit
All I/O ports are taken to pads
5V and 3.3V onboard regulators
ICSP connector for MPLAB-ICD2 or RealICE
D9 connector and level translator for RS232
Reset switch
Large prototyping area
Stackable with other Kiwacan prototyping boards
Ideal for rapid prototyping and one of product development.
Supplied in seveeral options: 1.Starter Kit Connector (/B) 2. Connector + PSU (/C) 3. Completely assembled
EJTAG Connector
LCD Connector
10MBit Ethernet using ENC28J60 chipset (Wired for TCP/IP Stack Demo)
SPI EEPROM (For TCP/IP Stack)
MicroSD/TransFlash Connector
Schematic (Jpeg)(Datasheet being written soon)
|
KPIC-100SP
|
Supports 3.3V 100 Pin TQFP 0.5mm pitch PIC24, PIC32 and dsPIC33 microcontrollers
Supports 100pin PIM (Plug In Module) supplied by Microchip
All I/O ports are taken to pads
5V and 3.3V onboard regulators
ICSP connector for MPLAB-ICD2 or RealICE
D9 connector and e=level translator for RS232
32.768MHz and 8MHz Crystal options
Reset switch
Large prototyping area
Stackable with other Kiwacan prototyping boards
Ideal for rapid prototyping and one of product development.
Supplied as bare board or pre-assembled with device or pre-assembled for PIM
NOTE:Prototype Shown - Following features have been added since.
EJTAG connector
Schematic (Jpeg)
(Datasheet being written soon)
|
KPIC-0820P
 |
Supports most 8,14,18 and 20 Pin PIC12,PIC16 and PIC18 Microcontrollers
All IO pins are available for use
PSU, Reset, Oscillator and Serial circuitry can be fitted
Stackable with other Kiwacan prototyping boards (KPIC/KAVR etc)
Datasheet: DS-KPIC-0820P_060319.pdf
(Note: This is the old datasheet and is being re-written soon)
|
KPIC-2840P
 |
Supports most 28 and 40 Pin PIC12,PIC16 and PIC18 Microcontrollers
Supports some dsPIC30, PIC24 and dsPIC33 with modification.
All IO pins are available for use
PSU, Reset, Oscillator and Serial circuitry can be fitted
Stackable with other Kiwacan prototyping boards (KPIC/KAVR etc)
Datasheet: DS-KPIC-2840P_060320.pdf
(Note: This is the old datasheet and is being re-written soon)
|
KPIC-6480S
 |
Supports most 64 and 80 Pin PIC16, PIC18, PIC24, PIC32, dsPIC30 and dsPIC33 Microcontrollers
All IO pins are available for use
PSU, Reset, Oscillator and Serial circuitry can be fitted
Stackable with other Kiwacan prototyping boards (KPIC/KAVR etc)
Schematic (Jpeg)
(Datasheet being written soon)
|
|
